Firstly ensure that you have the 5-pin midi cables connected correctly: the MIDI IN of your cable attaches to the MIDI OUT of your MIDI hardware device and the MIDI OUT of your cable attaches to the MIDI IN of your MIDI hardware device. ---------------------------- If you are using a Mac, ...
Our PlayAUDIO12 live playback interface has a very fast failover time. This is to ensure that if you have a situation where your main computer goes down and the PA12 switches to your backup system that your audience never hears a glitch in your playback. However sometimes our failover...
If you have performed a sample rate change sometimes the Inputs and Outputs of the PlayAUDIO12 will default to 8 Out and 8 In. To fix this you will need to reset the interface to Factory Defaults in Auracle (or change it in iConfig to be 2 in 14 out). After you commit the changes it should work pr...
In this video Travis will walk you through how to set up multiple PlayAUDIO12 interfaces.
Why do I need to synchronize my Pro Tools (PT) session? When you are running a redundant rig it is very important that both computers are in sync so that if a failover should occur the audio and MIDI tracks are perfectly in time and you don't miss a beat. Do I need extra cabling or to create sp...
The mio10 is somewhat misnamed. Most people think that it has 10 MIDI ports - but it actually has lots more MIDI ports than you might think! 10 DIN-MIDI ports: those are the round sockets with 5 pins 10 USB-MIDI ports: if you connect a USB hub to our special USB-MIDI Host port you can co...
Wondering how to test if your mio1 or iConnect MIDI1+ are working properly? In this short video, Travis shows you how!
While the iCM2+ can be powered by the optional power transformer, it is only completely necessary when you have an iOS device connected. You can power the interface two other ways without the power transformer: by connecting a computer to USB port 2 on the iCM2+ by connecting a standard USB...
iConnectMIDI2+ firmware upgrade can only be done when the computer is connected to the USB 2 Device Jack on iConnectMIDI2+. Disconnect any devices on the iConnectMIDI2+ and disconnect the iConnectMIDI2+ from your computer. Open your Mac’s Audio MIDI Setup and remove any iConnectMIDI2+...
When attempting to update the firmware with the iConfig application, the status declares that it’s rebooting to boot-loader mode, then a pop-up notifies of a communication error, and nothing happens. No firmware update actually takes place. For successful firmware upgrades on the iConnectMIDI...
iConnectAUDIO4+ firmware upgrade can only be done when the computer is connected to the USB 1 (2.1A) Device Jack on iConnectAUDIO4+. Disconnect any devices on the iConnectAUDIO4+ and disconnect the iConnectAUDIO4+ from your computer. Open your Mac’s Audio MIDI Setup and remove...
The ConnectAUDIO 2/4 doesn't have any software configurable functions. It is configured solely via the interface front panel. We suggest downloading Auracle and running it to ensure you have the latest firmware installed. After that, just use the front panel control.
There are two main functions of the Control jacks on the iConnectivity PlayAUDIO12 interface: Arming the automatic failover functionality Switching scenes The Control sockets are designed to accept TRS (Tip, Ring, Sleeve) jacks: Footswitch control You should normally be able to just att...
